Aeon Labs Micro Illuminator Manuel de service télécharger pdf

AEO_MEI

Micro Illuminator

Firmware Version : 1.24

Quick Start

A This device is a Z-Wave Actuator.

Single click the button located near the Status Indication LED or alternatively press the external switch/ button control quickly 6

times to include or exclude the device. If the Aeon Labs Micro Illuminator is not included into any Z-Wave network, the LED will be

blinking slowly continually.

Please refer to the chapters below for detailed information about all aspects of the products usage.

Product description

The Aeon Labs Micro Illuminator is a Z-Wave light dimmer specifically used to enable Z-Wave command and control (on/off/dim) for

existing in-wall dimmers. The wireless module is powered from the mains supply and is a three-wire design which requires a

neutral connection. In the event of power failure, non-volatile memory retains all programmed information relating to the units

operating status.

Installation Guidelines

The device is designed for a 3 wire system which requires a neutral connection. The module is powered from the main supply.

The schematic below shows how to wire the actuator. The power supply and the appliance are connected by the Load, Power Input

and Neutral connectors. The 3.3 Volt and External Switch connectors are for external switching.

After the electrical installation the device has to be implemented in the Z-Wave Network.

1 2 3 4 5

Page 2

Page 3

Page 5

Pas de commentaire

Aeon Labs Micro Illuminator Manuel de service